Documentation Center

How to generate a Report

Reports in SDL Trados Studio display data that was collected when batch tasks were run on the project files. Some batch tasks are run when a project is created and others you can run at any time. If the report you want to view is not available, it is because you need to run the batch task that generates the report data.

See How to Run a Batch Task or Task Sequence and select the corresponding batch task listed below to generate the report.

To generate theRun the
Analyze Files report,

Analyze files batch task. The data that appears in this report is generated during project creation. You can also run the report at anytime during the project life-cycle.

Apply PerfectMatch report

Analyze files batch task. The data that appears in this report is generated during project creation. You can also run the report at anytime during the project life-cycle.

Pre-translate report,

Analyze files batch task. The data that appears in this report is generated during project creation. You can also run the report at anytime during the project life-cycle.

Translation Count report,

Analyze files batch task. You can run the report at any time during the project life-cycle. This task is also included in the Analyze Only task sequence.

Verify Files report,

Analyze files batch task. You normally run this task after files have been translated and/or reviewed.

Word Count report,

Analyze files batch task. You can run the report at any time during the project life-cycle.

Update Main Translation Memories report,

Analyze files batch task . You normally run this task at the end of the project life-cycle after files have been translated and reviewed. This task is also part of the Finalize task sequence.

Update Project Translation Memories report,

Analyze files batch task. You can run this task at any time during the project life-cycle.