Documentation Center

Specifying settings for the QA checker

Specify the settings used when quality assurance (QA) checks are performed on your files, to fine tune your translation.

Procedure

  1. Choose where you want to specify the settings.
    • To specify verification settings for your active project, select Project Settings > Verification.
    • To specify verification settings for future projects, select File > Options > Verification.
  2. In the navigation tree, select QA Chekcer 3.0 from the navigation tree.
  3. Specify the settings for the following:
    • Segments verification
      Enables you to check that segments are completed correctly and there are no missing translations, for example.
    • Segments to exclude
      Enables you to skip certain segments, for example, if a PerfectMatch has already been found.
    • Inconsistencies
      Enables you to check for inconsistencies if the same text is rendered in several different ways.
    • Punctuation
      Enables you to make sure that punctuation is correct. For example, in some countries, certain punctuation rules have to be observed.
    • Numbers
      Enables you to check that numbers, times and dates are correct.
    • Word list
      Enables you to specify the correct form of a word that should be used. For example, you could specify to only use website as one word and not two.
      Regular expressions
      Enables you to set up regular expressions.
    • Trademark check
      Enables you to check that trademarks are used correctly.
    • Length verification
      Enables you to check that the length is no longer than a specified number of characters.
    • QA Checker profiles
      Enables you to save, switch and share QA Checker profiles. Profiles contain the settings specified on all of the pages in the QA Checker 3.0 settings.
  4. Select OK to save your settings and close the dialog.