Specifying settings for the QA checker
Specify the settings used when quality assurance (QA) checks are performed on your files, to fine tune your translation.
Procedure
- Choose where you want to specify the settings.
- To specify verification settings for your active project, select .
- To specify verification settings for future projects, select .
- In the navigation tree, select QA Chekcer 3.0 from the navigation tree.
- Specify the settings for the following:
-
- Segments verification
- Enables you to check that segments are completed correctly and there are no missing translations, for example.
-
- Segments to exclude
- Enables you to skip certain segments, for example, if a PerfectMatch has already been found.
-
- Inconsistencies
- Enables you to check for inconsistencies if the same text is rendered in several different ways.
-
- Punctuation
- Enables you to make sure that punctuation is correct. For example, in some countries, certain punctuation rules have to be observed.
-
- Numbers
- Enables you to check that numbers, times and dates are correct.
-
- Word list
- Enables you to specify the correct form of a word that should be used. For example, you could specify to only use website as one word and not two.
- Regular expressions
-
Enables you to set up regular expressions.
-
- Trademark check
- Enables you to check that trademarks are used correctly.
-
- Length verification
- Enables you to check that the length is no longer than a specified number of characters.
-
- QA Checker profiles
- Enables you to save, switch and share QA Checker profiles. Profiles contain the settings specified on all of the pages in the QA Checker 3.0 settings.
-
- Select OK to save your settings and close the dialog.